If you’ve ever experienced a toilet that won’t flush, you know how frustrating it can be.

Fortunately, replacing a toilet handle is a relatively simple and inexpensive home repair that can be done in just a few steps.

In this article, I’ll walk you through the process of how to replace a toilet handle, from gathering the necessary materials to the final installation.

How to Replace a Toilet Handle: A Step-by-Step Guide
How to Replace a Toilet Handle: A Step-by-Step Guide

What is a toilet handle?

A toilet handle is an important part of any toilet, as it is used to flush the toilet.

Over time, the handle can become worn or damaged, and it may need to be replaced.

Replacing a toilet handle is a relatively easy job that can be done with a few basic tools and materials.

In this article, we will discuss the steps necessary to replace a toilet handle, as well as some tips for troubleshooting any issues that may arise.

Step 1: Turn Off the Water Supply

The first step in replacing a toilet handle is to turn off the water supply.

This can be done by locating the water supply valve, which is usually located behind the toilet or under the sink.

Once the valve has been located, turn it off by turning it clockwise until it is completely closed.

Step 2: Remove the Old Handle

Once the water supply has been turned off, the next step is to remove the old handle.

To do this, first, remove the tank lid and set it aside.

Then, unscrew the handle from the tank.

Once the handle has been removed, disconnect the chain from the flush lever.

Step 3: Install the New Handle

Next, attach the new handle to the flush lever.

Make sure that the handle is securely attached and that the chain is connected to the flush lever.

Once the handle is in place, secure it to the tank with the screws provided.

Step 4: Turn On the Water Supply

After the new handle is installed, turn the water supply valve back on.

Make sure to turn it counterclockwise until it is completely open.

Then, check for any leaks around the handle or the tank.

If there are any leaks, tighten the screws or check the connections.

Conclusion

Replacing a toilet handle is a relatively easy job that can be done with a few basic tools and materials.

The steps involved include turning off the water supply, removing the old handle, installing the new handle, and turning the water supply back on.

If any issues arise during the process, make sure to check the connections and tighten the screws.

With a few simple steps, you can easily replace a toilet handle and get your toilet back in working order.

Frequently Asked Questions

Q: How do I replace a toilet handle?

A: Replacing a toilet handle is a relatively simple process that requires a few basic tools.

You will need a flathead screwdriver, a Phillips head screwdriver, a pair of pliers, and a replacement handle.

Start by turning off the water supply to the toilet and flushing it to empty the tank.

Unscrew the handle and remove it, then unscrew the nut on the inside of the tank and remove the flush lever.

Install the new handle and tighten the nut, then reattach the handle to the outside of the tank.

Finally, turn the water supply back on and test the handle to make sure it is working properly. 

Q: What tools do I need to replace a toilet handle?

A: To replace a toilet handle, you will need a flathead screwdriver, a Phillips head screwdriver, a pair of pliers, and a replacement handle.

Categorized in: